|
 |
|
Power:
0.5 to 100 HP |
Nominal dia: 4", 6" & 8" |
These motors are
Eco-friendly wet type, water filled and rewindable. The stator windings
are made of waterproof synthetic film insulated copper winding wires.
The stator shell of these motors is made of high- grade 304/316
stainless steel and housings of all 4" and 6" motors are provided with
Stainless steel shells. All the rotating parts of these motors are
dynamically balanced to maintain uniform clearance, better efficiency
and better life cycle. Specially designed high performance thrust
bearing are used to withstand high axial & upthrust loads with minimum
wear & tear.
�O�
rings, shaft seals and sand guard are used to avoid ingress of well
water, sand and fiber particle into the motor. Pressure equalizing
rubber diaphragm is provided to compensate the volume & pressure
variation of water inside the motor, caused due to temperature rise. It
features water lubricated thrust and journal bearings. Motor is pre
filled with clear, cold, pure, fresh, filtered water. However, on
request motors can be pre-filled with water and propylene glycol
(Anti-freeze) for places where the temperature is below the freezing
conditions. It is mandatory to install C.R.I. control boxes for all
single phase motors.
|
Applications
These submersible motors are designed to couple with any NEMA standard deepwell
submersible pump ends used for, Irrigation Domestic , Civil water supply ,
Fountains , Industrial water supply , Pressure boosting units , Fire fighting
, Ponds , Gardens , Sprinkler systems and mining.
Special Features
Rewindable design , Dynamically balanced rotor , Higher power factor resulting
in better efficiency , Copper rotor for higher starting torque , Specially
designed thrust bearing to withstand high axial thrust loads , Winding made of
synthetic film insulated copper wire to withstand high temperature , Highly
durable. All single phase motors are equipped with thermal protector
|
Products 
